Maglock to Electric Strike Conversion: Restoring Reliable Egress on a Critical Access Door
How Can We Help You?
A Commercial Security Project in Colorado Springs
The Problem
A critical door was running on a fail-safe maglock. In a maglock setup, the door stays locked only when powered, so any power loss releases it. The existing panic hardware only cut power to the magnet. This left the door dependent on the electrical circuit for both security and egress, with no mechanical fallback if the system faltered.
The goal was a door that guarantees free exit at all times, holds secure by default, and still ties into the building’s existing access control system without a full rebuild.
The Solution
We converted the door to a fail-secure electric strike paired with new mechanical panic hardware, reusing the original power circuit to keep cost and downtime down.
- Onsite review of the existing hardware, plus a conversation with the tenant to confirm the outcome they needed.
- Measurements taken and a written estimate provided.
- On approval and deposit, parts ordered and installation scheduled.
- Removed the old panic hardware, which held only a power cut-off switch, and stripped out the unneeded wiring and cable.
- Prepped the door for the new key cylinder and panic hardware, then installed a mechanical Falcon panic bar.
- Prepared the door frame to accept an HES 9400 electric strike.
- Disconnected the power cables at the old maglock and rerouted them through the frame to feed the strike.
- Connected the strike to the existing power cables and handed off to the tenant’s IT department to configure it as fail-secure in their access controller.
- Fabricated and installed a cover plate over the aluminum channel gaps left by the strike modification, for a clean finished look.
Total site time was under four hours, with the access control system back up and fully functional.
The Result
The door now has a mechanical Falcon panic bar for guaranteed free egress, independent of power, and an HES 9400 fail-secure electric strike running on the original maglock circuit, ready for IT to configure. The whole conversion took under four hours, with the access control system restored and operational.
Existing power reused, minimal downtime, clean finish. That is the difference between a locksmith who swaps hardware and one who understands how the door, the egress code, and your access control system have to work together.
Need a critical door reviewed or converted?
If a door in your building relies on power to stay safe, or your egress hardware does not meet what a life-safety door demands, let us evaluate your security system before it fails at the worst possible time.
Call ApexAccess Security at (719) 203-1374 for a commercial access control review.
